Introduction

Configuration

Download

FAQ

History

Installation

Known Issues

Licence

Listings

Log File

Release Notes

Report Bugs

Screen Shot

Suggestions

Using

Key Configuration Latest Version: 2.4 Size: 491KB Released 03-February-2009

This program is no longer being maintained.

Below is a screen shot of the configuration screen showing the various parameters that can be set. By default the program runs in the System Tray, to access the configuration file double click on the tray icon and then click the Configure button from the main screen. Hovering over the various fields will display the tool tips with extra information. Errors will be flagged by a status message at the bottom of the screen when Save is clicked and the parameter(s) involved will also be highlighted. Any errors must be fixed before new data can be saved. The configuration screen for the KeyOff Slave is similar. When the configuration screen is opened program operation is inhibited until it is closed when the program will be reset if any parameter changes have been saved. Communications to the Slave are not inhibited while the configuration screen is open. Saving configuration changes needs administrator privileges. The configuration file can be found in the data directory of the main program (usually c:\program files\JSutils\KeyOff\Data).

The Log Level can be set to None, Normal or Full. If the log file path is chan 06-May-2009 be created manually and the permissions set to suit the required operation if it does not already exist before running the program. If the log level is set to Full configuration details are written to the log file when the configuration screen is closed if any changes have been saved, in addition configuration details are written to the log file each time the program starts.

Monitor Mode can only be used on the main program when KeyOff is used to control a remote computer. It can not be used on KeyOff Slave.

When using the remote slave you can use either an IP address or if the domain name check box is ticked a fully qualified domain name (on systems without a Directory Name Server you can also use the computer name). Only change the communications port if the program gives an error message indicating a clash with another program, if you do this remember to change both main and slave programs to the same port.

The configuration screen will timeout after 600 seconds if left open, there is a warning message 90 seconds before this happens.